Microhard Systems IPN3G - Page 159

© Microhard Systems Inc. 159
5.0 AT Commands
AT+MCODF
Command Syntax
Set COM1 data format.
AT+MCODF=<data format>
Data Format:
0 8N1
1 8N2
2 8E1
3 8O1
4 7N1
Description
Example
Input:
AT+MCODF=0<enter>
Response:
OK
AT+MCOFC
Command Syntax
Set COM1 flow control.
AT+MCOFC=<Value>
0 None
1 Hardware
2 CTS Framing
Description
Example
Input:
AT+MCOFC=0 <enter>
Response:
OK
AT+MCOPRDD
Command Syntax
Set COM1 port pre-data delay (ms)
AT+MCOPRDD=<delay_ms>
Description
Example
Input:
AT+MCOPRDD=100<enter>
5 7N2
6 7E1
7 7O1
8 7E2
9 7O2
AT+MCOPODD
Command Syntax
Set COM1 port post-data delay (ms)
AT+MCOPODD=<delay_ms>
Description
Example
Input:
AT+MCOPODD=100<enter>
The AT&W command
must be issued to save
changes!