Microplex LOGIJET T4 - Page 134

134 Using the RFID Functions
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
Panel display Explanations, Remedies
[RFID Error ]
[DataReadTimeOut ]
or
[RFID Error ]
[DataWriteTimeOut ]
An RFID command (read, program, etc.) has
failed to complete in the maximum amount of
allowed time.
- increase the number of retries *
See section 8.2.4 Adjusting the Number of
RFID Access.
- make sure the media has been
loaded correctly
(compare section 5.2)
- if you made supply or print position settings,
make sure the RFID tag was set to the right
position
- see section 8.2.3 Adjusting the Transponder
Position (Tag Position), too.
* Note: The RFID printer pauses while
programming the RFID tag