Microplex LOGIJET T4 - Page 5

Contents 5
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
Chapter Page
7.23. Contrast (Density) Setting 85
7.24. Image Shifting to the X-Direction 86
7.25. Image Shifting to the Y-Direction 88
7.26. Selecting the Light Sensor Type 90
7.27. Automatic Sync Sensor Adjust 91
7.27.1. Overview 91
7.27.2. Example 92
7.28. Manual Sync Sensor Adjust 93
7.28.1. Overview: Level and Current Adjusting 94
7.28.2. Description of Level and Current Adjusting 95
7.28.3. Example 96
7.29. Peripheral Device Activation (Tear Off Edge, Cutter) 98
7.30. Selecting the Tear Off Mode (Option: Cutting Mode) 100
7.31. Selecting the Print Mode 102
7.32. Adjusting the Tear Off Position (Option: Cutting Position) 105
7.33. Configuration of Network Parameters (IP Address, e.g.) 106
8. Using the RFID Functions 109
8.1. Integrated RF Write/Read module 109
8.1.1. CE - Conformity 109
8.2. RFID Panel Functions 111
8.2.1. Selecting the RFID Mode 111
8.2.2. Selecting the Communication Protocol 112
8.2.3. Adjusting the Transponder Position (Tag Position) 113
8.2.4. Adjusting the Number of RFID Access (Timeout) 119
8.2.5. Adjusting the Transmission Speed (Bit Rate) 120
8.2.6. Reading the Label Identification Number automatically 121
8.3. Data Interface Status Out 122
8.4. IDOL Commands for RFID 123
8.4.1. Overview Function Group RFID 123
8.4.2. Reading the Label ID Number (Prior to the Print Process) 126
8.4.3. Writing Data into a Data Block of the RFID Label 127
8.4.4. Generating a Page ID Number, Receiving the RFID data after Printing 128
8.5. Syntax of RFID Data (Status Messages) 130
8.6. RFID Errors 132