Microplex SOLID 50 A3 - 3 - Symbol Code Selection

Panel Functions 101
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID 50 A3 - 3 Edition 2.1
5.23. Symbol Code Selection
This function selects the active symbol code.
Panel display
[SOLID 50 A3 - 3 ]
[Menu Level1 ]
  
[Page Menu ]
[Font Number ]
  
[Symbol Code ]
[902, IBM PC-II ]
  
[901, IBM PC-I ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
Press the NEXT or PREVIOUS key until
[Page Menu ] is displayed.
Press the NEXT or PREVIOUS key until
[Symbol Code ] is displayed.
Press the NEXT or PREVIOUS key until
the desired symbol code is displayed.
The symbol code 901, IBM PC-I is
selected.
In addition this new value can be
saved as setup value (using the SELECT
key), before the printer is turned ON
LINE again.