Microplex SOLID 50 A3 - 3 - Print Direction Selection

Panel Functions 89
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID 50 A3 - 3 Edition 2.1
5.14. Print Direction Selection
This function selects the active print orientation (orientation of the
whole printout including graphics, etc. on the paper).
Panel display
[SOLID 50 A3 - 3 ]
[Menu Level 1 ]
  
[Paper Menu ]
[Feeder Select ]
  
[Print Direct. ]
[Print Direct. 0 ]
  
[Print Direct. 1 ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
Press the NEXT or PREVIOUS key until
[Paper Menu ] is displayed.
Press the NEXT or PREVIOUS key until
[Print Direct. ] is displayed.
Press the NEXT or PREVIOUS key until
the desired print direction is
displayed.
The print direction 1 = landscape is
selected.
In addition this new value can be
saved as setup value (using the
SELECT key), before the printer is
turned ON LINE again.
Print direction assignment:
Print direction 0 = Portrait (upright format)
Print direction 1 = Landscape (horizontal format)
Print direction 2 = Portrait upside down
Print direction 3 = Landscape upside down