Microplex SOLID 50 A3 - 3 - Text Margin Configuration

102 Panel Functions
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID 50 A3 - 3 Edition 2.1
5.24. Configuration of Text Margins
This function sets text margins. Margins are expressed in dots at
the concerning edge of the paper.
Panel display
[SOLID 50 A3 - 3 ]
[Menu Level 1 ]
  
[Page Menu ]
[Font Number ]
  
[Margin ]
[Left ]
  
[from Right ]
[Digit4 0081]
  
[Digit1 0087]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
Press the NEXT or PREVIOUS key until
[Page Menu ] is displayed.
Press the NEXT or PREVIOUS key until
[Margin ] is displayed.
Press the NEXT or PREVIOUS key until
the desired margin is displayed.
Pressing the NEXT or PREVIOUS key
changes the value of the current
position (Digit 4 = left position, in this
example: 0). Pressing the SELECT key
moves you to the next position (the
RETURN key moves you back).
The right margin is changed to 87 dot.
In addition this new value can be
saved as setup value (using the SELECT
key), before the printer is turned ON
LINE again.