Microplex SOLID 50 A3 - 3 - Choosing Print Resolution

74 Panel Functions
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID 50 A3 - 3 Edition 2.1
5.3. Choosing Print Resolution
This function allows the user to choose the current print resolution.
If, after a particular resolution is chosen, the print data stream
indicates a different resolution (e.g. via a WINDOWS print
driver), the second print resolution will be used only for that job.
Panel display
[SOLID 50 A3 - 3 ]
[Menu Level 1 ]
  
[Engine]
[Resolution]
[300 dpi ]
  
[600 dpi ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
Press the NEXT or PREVIOUS key
until [Engine ] is displayed.
Menu item Engine is selected.
Menu item Resolution is selected.
Press the NEXT or PREVIOUS key
until the desired resolution (e.g. 600
dots per inch) is displayed.
600 dpi resolution is selected.
In addition this new value can be
saved as setup value (using the
SELECT key), before the printer is
turned ON LINE again.