Microplex SOLID 50 A3 - 3 - Transparent Code Adjustment

94 Panel Functions
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID 50 A3 - 3 Edition 2.1
5.18. Transparent Code Adjustment
This function configures the transparent code. Using the transparent code enables
you to initiate the commands of the page description language IDOL by printable
characters. The transparent code pre-setting is 2625. These are the ASCII character
codes (hexadecimal) for the characters   (ref. IDOL Programming Manual).
Panel display
[SOLID 50 A3 - 3 ]
[Menu Level 1 ]
  
[Configuration ]
[Interface]
  
[Transparent Code ]
[Digit4 2625]
  
[Digit1 2626]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
Press the NEXT or PREVIOUS key until
[Configuration ] is displayed.
Press the NEXT or PREVIOUS key until
[Transparent Code ] is displayed.
The hexadecimal number for   is preset.
Activating the NEXT or PREVIOUS key
changes the value of the current position
(Digit4 = left position, in this example: 2).
Pressing the SELECT key moves you to the
next position (the RETURN key moves you
back).
2626 is selected as transparent code. From
now on use the characters   before
programming the IDOL commands.
In addition this new value can be saved as
setup value (using the SELECT key), before
the printer is turned ON LINE again.