Microplex SOLID 50 A3 - 3 - Lines per Inch Setting (Line Spacing)

Panel Functions 107
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID 50 A3 - 3 Edition 2.1
5.27. Lines per Inch Setting (Line Spacing)
This function sets the number of lines per inch. This setting is effective
only in case of using the printer as a line printer.
With a small number of lines per inch, line spacing will be relatively
large. (Ref. IDOL Programming Manual).
Panel display
[SOLID 50 A3 - 3 ]
[Menu Level 1 ]
  
[Page Menu ]
[Font Number ]
  
[Line Spacing ]
[Digit4 006.5 ]
  
[Digit1 010.0 ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
Press the NEXT or PREVIOUS key until
[Page Menu ] is displayed.
Press the NEXT or PREVIOUS key until
[Line Spacing ] is displayed.
6.5 lpi = currently set value.
(lines per inch).
Pressing the NEXT or PREVIOUS key
changes the value of the current digit
(Digit 4 = left position, in this example:
0). Pressing the SELECT key moves you
to the next digit (the RETURN key
moves you back, if need be).
The number of lines per inch was
increased to 10 lpi.
In addition this new value can be
saved as setup value (using the SELECT
key), before the printer is turned ON
LINE again.