Microplex SOLID 50 A3 - 3 - Reduced Print Quality Issues

Troubleshooting 127
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID 50 A3 - 3 Edition 2.1
7.2. Reduced Print Quality
Defect
Printout too light
Remedies
- If the message [Toner Low ] or the message
[Toner Empty !] is displayed, replace the
toner cartridge
(see section 3.2: Toner Cartridge Replacing).
- If the message [Drum Near End ] or the
message [Drum Cartr.Err]
[J6-1, Life End ] is displayed,
replace the drum
(see section 3.3: Drum Cartridge Replacing).
- Do not use damp paper.
- If you must print on special paper, please
consider finding the most appropriate paper
type.
- Check the environmental conditions and
change them if necessary.
Make sure you know the admissible values for
relative humidity, temperature etc..
See also section 2.4: Printer Installation.
Toner residues on the
back side of the
printouts
- Clean the printer
If the remedies above are not successful, please contact a MICROPLEX
authorized service engineer.