Microplex SOLID 50 A3 - 3 - Network Parameters Configuration

110 Panel Functions
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID 50 A3 - 3 Edition 2.1
5.30. Configuration of Network Parameters (IP Address, e.g.)
The functions of the submenu Network are used to set the
parameters for connecting the printer to a network (Ethernet).
Setting the IP address manually:
Panel display
[SOLID 50 A3 - 3 ]
[Menu Level 1 ]
  
[Network ]
[Timeout ]
  
[Ethernet ]
[Duplex/Speed ]
  
[IP Assign ]
[Off ]
  
[Manual ]
[IP Address ]
[192.168.002.002 ]
  
[192.168.010.123 ]
[Saved ! ]
Notes
Turn the printer OFF LINE with this key.
Press the NEXT or PREVIOUS key until
[Network ] is displayed.
Press the SELECT key to select the
network menu.
Press the NEXT or PREVIOUS key until
[Ethernet ] is displayed.
Press the SELECT key to select the
Ethernet menu.
Press the NEXT or PREVIOUS key until
[IP Assign ] is displayed.
Press the SELECT key to select the
IP Assing menu.
The current configuration is displayed.
Press the NEXT or PREVIOUS key until
[Manual ] is displayed.
Press the SELECT key to set the
IP address manually.
Pressing the NEXT or PREVIOUS key
changes the value of the current digit
(left digit first, in this example: 1).
Pressing the SELECT key moves you to
the next position (the RETURN key
moves you back, if need be).
The new IP address is saved as setup
value.
The printer is turned ON LINE again.