Microplex SOLID 50 A3 - 3 - Hexdump-Mode Activation

76 Panel Functions
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID 50 A3 - 3 Edition 2.1
5.4. Hexdump-Mode Activation
In the Hexdump-Mode the printer prints all characters received
via interface without any interpretation (hexadecimal coded).
This mode helps with error diagnosis. The Hexdump-Mode can
be activated only temporarily.
Panel display
[SOLID 50 A3 - 3 ]
[Menu Level 1 ]
[Status Sheet ]
  
[Hexdump ]
[Hexdump ]
Notes
Turn the printer OFF LINE with this
key.
Menu Level 1 is selected.
Press the NEXT or PREVIOUS key
until [Hexdump] is displayed.
The Hexdump-Mode is activated.
The printer is turned ON LINE
again.
Note:
By activating the normal print mode (see next page) or by turning the
printer off and on again the printer can be taken out of Hexdump-Mode.
Time between turning the printer off and on again should be at least
15 seconds.