Microplex SOLID 50 A3 - 3 - Print Density Setting

Panel Functions 109
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID 50 A3 - 3 Edition 2.1
5.29. Print Density Setting
Using this function the density of the printed characters can be
changed.

Selecting a low print density value reduces the amount of toner on the
printed page. This may help lower the cost of printing.
Panel display
[SOLID 50 A3 - 3 ]
[Menu Level 1 ]
  
[Engine ]
[Resolution ]
  
[Density ]
[Density: 80 % ]
  
[Density: 60 % ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the NEXT or PREVIOUS key until
[Density ] is displayed.
The currently set value is displayed.
Press the NEXT or PREVIOUS key to
change the print density.
Values from 10% to 100% are
settable.
The print density is reduced to 60 %.
In addition this new value can be
saved as setup value (using the
SELECT key), before the printer is
turned ON LINE again.