OM-278680 Page 32
E. Calibrating Electrode Retraction
Select Calibrate Electrode Retraction (Figure 8-10) and press OK to perform the following functions for the AR Stick electrode:
• Recalibrate the electrode retraction rate. (Recalibrate electrode retraction rate only when instructed by Miller technical support.)
• Test electrode retraction functionality.
• Adjust the electrode rate scaling factor. The retraction rate depends on the parameters of the exercise but the rate can be scaled to be slower (80%)
or faster (120%), as desired. To adjust the scaling factor, select Increase Scaling Factor or Decrease Scaling Factor, and then press OK to
change the value. Press OK after making changes, or press Cancel to exit the menu without saving.
Figure 8-10. Calibrating Stick Electrode
F. Configuring TIG Foot Pedal
Select Configure Foot Pedal (Figure 8-11) and press OK to enable the TIG foot pedal (optional). Set foot pedal to ON, select Calibrate Pedal,
and follow on-screen instruction until the process is complete. See Section 5-12 for foot pedal connections.
When the foot pedal is enabled, TIG welding exercises will require the use of the foot pedal. In order to use the TIG torch trigger button, the foot
pedal must be disabled.
Figure 8-11. Configuring TIG Foot Pedal
To Next Page
Loading...
Need help?
General
