© 2014 MIMAKI ENGINEERING CO.,LTD.
4.2.19 P.1
1
2
3
4
5
6
7
8
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > ZI COMMAND
Model
CJV150/300
Issued
2014.09.15
Revised F/W ver. Remark
1.0
4.2.19 ZI COMMAND
Outline
Sets the response value for the ZI command (Mimaki plotter model response command).
Upon the application for checking the model of plotter with the ZI command, it makes this model recognized as the
conformable model if the model is not recognized as the conformable model. (Due to such reasons that the version is
old or the application is too old to use.)
In this case, new functions such as the mark detection or the like may not be usable.
Work procedures
1. Select [#ADJUST(CUT)] -> [ZI COMMAND].
2. The current setting is indicated by the [ENTER] key.
The default setting of this machine is “CJ300”.
3. Change the set value.
[]/[]: Change
[ENTER]: Fix
4. Register the set value by pressing the [ENTER] key.
This setting is effective when the MGL-IIc command is selected.
#ADJUST(CUT)
ZI COMMAND [ENT]
#ZI COMMAND
:CJ300
To Next Page
Loading...
