MIMAKI CJV150-107 - 4.2.2 STAGGER ADJUST

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.2.2 P.1
1
2
3
4
5
6
7
8
R.1.0
4.2.2 STAGGER ADJUST
 Outline
This adjustment is available for 300series.
A pattern for mechanical adjustment of positional deviation of each head is drawn.
Move the head height to the position of 2.0 mm print gap, and select a head to draw the adjusting pattern.
The pattern is drawn in only A (Magenta) raw of each head.
 Procedure
1. Move the adjusting lever to the right until the adjusting cam hits
it.
 It is necessary to perform SLANT adjustment before STAGGER adjustment.
 After adjusting the stagger, adjust the slant.
Align this row of
each head.
Adjustment pattern
Head 1
Head 2
Patterns of effective overlapping and not effective are
printed alternately
Adjusting lever
(for stagger adj.)
Adjusting lever
Adjusting cam
Rotates in tandem with the lever.
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > STAGGER ADJUST
Model CJV150/300 Issued 2014.09.15 Revised F/W ver. 1.00 Remark
1.0
Rev.