MIMAKI CJV150-107 - Chapter 6 Troubleshooting Overview

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.3.4 P.1
1
2
3
4
5
6
7
8
R.1.0
4.3.4 Adjustment of the Wiper Height
 Outline
Adjust the height of the wiper.
 Procedure
1. Loosen the wiper height adjusting screws (x2)
2. Adjust the distance in the left figure until the thickness gauge is
8 mm.
3. Loosen the screw and the miniature clamp lever on the P cover
U front, and then tighten the screws while holding the height
adjustment lever in the lowest position to fix the head in place.
4. Move the wiper base 30, and adjust the wiper so that there is
approximately 1.5 mm from the nozzle surface.
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode functions
mistakenly during the operation.
Wiper unit
Screws
Wiper base
30
CA base
8 mm
1.5 mm
Nozzle surface
Wiper
MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Adjustment of the Wiper Height
Model CJV150/300 Issued 2014.09.15 Revised F/W ver. 1.00 Remark
1.0
Rev.