© 2014 MIMAKI ENGINEERING CO.,LTD.
4.2.25 P.1
1
2
3
4
5
6
7
8
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > GR/PR POSITION
Model
CJV150/300
Issued
2014.09.15
Revised F/W ver. Remark
1.0
4.2.25 GR/PR POSITION
Outline
Makes the printer recognize the positional relation between the grid roller and the pinch roller.
Readjusts the position of grind roller and the pinch roller when the parameter has been initialized or when an error
occurs even if the position of the pinch roller is within an acceptable range upon media detection, and compensates
mechanical errors.
Procedure
1. Select [#ADJUST(CUT)] -> [GR/PR POSITION].
2. Move the cutter to the parking position.
[ENTER]:Cutter moves to the parking position.
3. Hold up the clamp lever.
(If it has been held up already, proceed to the next screen.)
4. Align the both right ends of the rightmost pinch roller and the
rightmost grid roller, and hold the lever down.
(Margin of error: within ± 0.5 mm)
[]/[]:
[ENTER]: Finalizes (To the next compensation screen)
5. Carry out automatic compensation by pressing [ENTER].
After the automatic compensation is completed, return to “main
menu” by pressing [END].
#ADJUST(CUT)
GR/PR POSITION [ENT]
#GR/PR POSITION
Head Cut Retruct:ent
LEVER UP
SET:PR POSITION
LEVER DOWN
Align the both right ends
#GR/PR POSITION
ACTION [ENT}
∗ failure ∗
* When the automatic correction failed
In case automatic compensation fails, a screen for Step
3 is displayed.
To Next Page
Loading...
