© 2014 MIMAKI ENGINEERING CO.,LTD.
4.2.23 P.1
1
2
3
4
5
6
7
8
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > PEN PRESSURE
Model
CJV150/300
Issued
2014.09.15
Revised F/W ver. Remark
1.0
4.2.23 PEN PRESSURE
Outline
The press value (the pen down pressure) is adjusted.
The adjusting pressure and writing destination of adjustment value are as follows: (“0 g” for the auto-setting)
Work procedures
1. Remove the media.
Set the cutter holder that is removed the cutter blade from the
cutter Assy. in the Tool Holder.
Arrange the pinch rollers at the center and ends of both sides
then make the rollers lowered.
2. Select [#ADJUST(CUT)] -> [PEN PRESSURE].
3. The pen moves to the MID position automatically.
* An error is indicated if no stroke information is available.
4. Press [ENTER] to perform the “0 g” adjustment (Auto adjust-
ment).
5. Pull up the adjustment the cutter holder with a tension gauge at
each pressure, and repeat up and down several times. Input the
value when the cutter holder starts leaving the sheet.
[]/[]: Pressure code Up/Down
[ENTER]: Fix/To next
6. Check the pen pressure according to the necessity.
[FUNCTION]: The pen pressure is indicated in 2 g pitch.
(Adjustable when pressed again)
7. End with the [END] key.
Adjusting pressure 0g 30g 60g 100g 200g 400g 600g
system parameter No.0123456
“0 g” auto-adjustment
#ADJUST(CUT)
PEN PRESSURE[EN
T]
#
PEN PRESSURE
START [ENT]
#
PEN PRESSURE
30g=233
Pinch roller pressure is “middle” for all pinch rollers.
Pull upward
with each
pressure.
In the same way, execute 60, 100, 200, 400, 600 g.
A buzzer sounds when lifted more than approx. 0.075.
To Next Page
Loading...
