MIMAKI CJV150-107 - Chapter 6: Ink Cartridge Warnings; Ink Cartridge Warning Display

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.3.7 P.1
1
2
3
4
5
6
7
8
R.1.0
4.3.7 Centering of the Roll Holder
 Outline
Carry out centering so that the axes of roller holder (axis of both feeding side and take-up side) are aligned, by
positioning them face-to-face.
 Adjustment procedure
1. Carry out centering so that the axes of roll holder are aligned by
positioning the feeding side and the take-up side face-to-face.
2. In case their axes are not aligned, make adjustment after
loosening the screws of the bushing.
3. After the both axes have been aligned, tighten up screws and
check for any misalignment of axis at the right, left and central
part of the main body.
Bad example: The axes of the right or left side of the
roller holder are out of alignment.
Good example: The axes of the roller holder
are in alignment.
Loosen
Loosen
MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Centering of the Roll Holder
Model CJV150/300 Issued 2014.09.15 Revised F/W ver. 1.00 Remark
1.0
Rev.