MIMAKI CJV150-107 - Chapter 4: Setting the CUT MODE; Chapter 4: Perform Multiple Cuttings (Copy Function)

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.2.5 P.1
1
2
3
4
5
6
7
8
R.1.0
4.2.5 DEFAULT SET
 Function
Returning each parameter to the initial value.
 DEFAULT SET List of Items
 Work Procedures
1. Select [#ADJUST] - [DEFAULT SET].
2. Select the parameter to be initialized, and then fix it by [ENTER].
[]/[]: Switch
[ENTER]: Confirms (to Confirmation display)
[END]: Return
3. Initialize by [ENTER].
[ENTER]: Execute
[END]: Return
No Item Operation Remarks
1 SYSTEM PARAMETER Initialize the parameter in question.
2 MAINTE PARAMETER Initialize the parameter in question.
3 SERVO PARAMETER Initialize the parameter in question.
4 FEED PARAMETER Initialize the parameter in question.
5 HEAD PARAMETER Initialize the parameter in question.
6 OPE PARAMETER Initialize the parameter in question.
7 INK PARAMETER 1 Initialize the parameter in question.
8 INK PARAMETER 2 Initialize the parameter in question.
9 DEBUG PARAM Initialize the parameter in question.
10 SCAN PARAMETER Initialize the parameter in question.
11 NOZLE RECOCVERY
PARA M
Initialize the parameter in question.
12 SHIPPING set Initializing parameters of others than the adjustments.
FUNCTION
#ADJUST [ENT]
#ADJUST
DEFAULT SET [ENT]
#DEFAULT SET
SYSTEM param. [ENT]
MAINTE PARAMETER
SERVO PARAMETER
:
#DEFAULT SET
INITIAL. OK? [ENT]
Parameter initialized
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > DEFAULT SET
Model CJV150/300 Issued 2014.09.15 Revised F/W ver. 1.00 Remark
1.0
Rev.