© 2014 MIMAKI ENGINEERING CO.,LTD.
4.2.26 P.1
1
2
3
4
5
6
7
8
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > PRINT/CUT POS.
Model
CJV150/300
Issued
2014.09.15
Revised F/W ver. Remark
1.0
4.2.26 PRINT/CUT POS.
Outline
Correct the mechanical position aberration of the print head and the nozzle, and raise the precision of printing and
cutting while the mark sensor is not used.
The machine draws registration marks with the print head and cut head, reads the positions of the marks with the
mark sensor and corrects the position error automatically.
Procedure
1. Select [#ADJUST(CUT)] -> [PRINT/CUT POS.].
2. Move the cutter head on the center of the platen.
[]/[]: Move
[ENTER]: Confirm, and then start adjustment
3. Press [ENTER] to start the adjustment.
① Print the mark with printer head.
Perform the switching operation for connection unit.
② Draw the mark with cutter head pen.
Detect the mark with mark sensor.
③ Draw the mark with cutter head pen again.
Correction values are calculated.
4. Check the correction values on the LCD and then press
[ENTER] to register correction values and complete the
adjustment.
X correction value
Y correction
value
Print pattern
(Printer head)
Re-Drawing pattern with pen
(Cutter head)
Drawing pattern with pen
(Cutting head)
#ADJUST(CUT)
PRINT/CUT POS. [ENT]
When [Connect/PR pres. change] is displayed, and
then press [ENTER].
#PRINT/CUT POS.
ORIGIN SET [ENT]
#PRINT/CUT POS.
PRINTING
Mark Print
(Print Head)
Switching to cutter head
Mark drawn
(Cutter Head)
Position of mark detected
Mark drawn
(Cutter Head)
and correction values
calculated
If a mark detection error occurs, execute “4.2.24
PHOTO SENSOR” and perform this adjustment again.
Pressing [END] will terminate the adjustment without
registering the correction values.
To Next Page
Loading...
