MIMAKI CJV150-107 - 6.4.8 Encoder PCB Assy

© 2014 MIMAKI ENGINEERING CO.,LTD. 6.4.8 P.1
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Disassembly and Reassembly > Electrical Parts > Encoder PCB Assy
Model CJV150/300 Issued 2014.09.15 Revised F/W ver 1.00 Remark
1.0
Rev.
6.4.8 Encoder PCB Assy
 Work procedures
1. Remove the Front cover M, L and Carriage cover.
2. Loosen the screws at two locations on the right and left to
remove the Carriage cover stay.
3. Remove the connector.
4. Remove the Encoder sensor BKT (screw x1).
5. Remove the two screws and then remove the Encoder PCB
Assy.
6. Reverse the disassembly procedure for reassembly.
Turn the main power OFF when turning the power OFF.
It is very dangerous if sleep mode functions mistakenly during the operation.
Encoder PCB Assy
Carriage cover stay
Encoder sensor BKT
Connector
Encoder PCB Assy.
Encoder sensor BKT
R.1.0