MIMAKI CJV150-107 - 4.3.1 Adjustment of the Carriage Slant

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.3.1 P.1
1
2
3
4
5
6
7
8
R.1.0
4.3.1 Adjustment of the Carriage Slant
 Outline
Perform carriage vertical-tilt and slant adjustment for right and left directions.
 Procedures
 Preparations
1. Move the carriage onto the platen.(The position of the second
clamp from the right is recommended.)
2. Move the Head height adjust lever to the lowest position.
3. Move the clamp lever downward.
4. Remove the cutter unit. (Refer to 6.6.1 Cutter Unit)
 Height for right and left (slant for right and left) adjustment
5. Loosen the adjusting screws (4 places of both sides).
Be sure to wear protective glasses and working gloves during the operation.
Ink may get into your eyes depending on the working condition, or hand skin may get rough if you touch
the ink.
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode functions
mistakenly during the operation.
Head height adjust lever
Be sure to perform adjustment with the clamp lever
down. In addition, the head initialization height shall
be L range setting.
Adjusting screws x4
MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Adjustment of the Carriage Slant
Model CJV150/300 Issued 2014.09.15 Revised F/W ver. 1.00 Remark
1.0
Rev.