MIMAKI CJV150-107 - 4.3.3 Adjustment of the Station Height

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.3.3 P.1
1
2
3
4
5
6
7
8
R.1.0
4.3.3 Adjustment of the Station Height
 Outline
Adjust the height of the station.
 Procedure
1. Remove the Cover R, Cover R2 and Undercover R.
2. Loosen the 4 screws used for CA base adjustment.
3. Loosen the hexagon socket head screws (x3) and make an
adjustment to set their thickness gauge at 5 mm, then tighten the
nuts.
4. Tighten up 4 loosened screws used for CA base adjustment
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode functions
mistakenly during the operation.
CA base
Loosen x4
hexagon socket head screw x3
5mm
Adjust by rotate x3
Tighten after
adjusting
MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Adjustment of the Station Height
Model CJV150/300 Issued 2014.09.15 Revised F/W ver. 1.00 Remark
1.0
Rev.