MIMAKI CJV150-107 - Chapter 6: Specific Operational Error Messages; Print Area, Parameter, and Command Errors; Media and Registration Mark Errors

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.3.9 P.5
4.3.9 Parallelism adjustment of the Tension Bar
1
2
3
4
5
6
7
8
17. If the parallelism is wrong, loosen the four screws affixing the
roll guide BKT L or the roll guide BKT R.
18. Slide the roll guide BKT towards you while checking the
position of the tape, and tighten the four screws when
parallelism is achieved.
• If the second piece of tape surpasses the first
(Wrong (1)):
Slide the roll guide BKT L towards you to adjust it.
• If the second piece of tape does not reach the first
(Wrong (2)):
Slide the roll guide BKT R towards you to adjust it.
Wrong case 2
Roll guide BKT R
Screw x4
The T bar is installed pressed against the machine
side. Move it towards you during adjustment.
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Parallelism adjustment of the Tension Bar
Model CJV150/300 Issued 2014.09.15 Revised F/W ver. 1.00 Remark
1.0
Rev.