MIMAKI CJV150-107 - Page 132

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.3.10 P.2
4.3.10 Adjusting the Location of Mark Sensor
1
2
3
4
5
6
7
8
2. Insert the clearance gauge between the pen line film and the
bottom surface of the T sensor cover.
3. Check whether the right and left T sensor covers are fixed under
the conditions that each of them is in close contact with the
clearance gauge, then tighten up the screws.
Jig for adjusting the height
of CJV mark sensor
T Sensor Cover
Fix.
Press against.
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Adjusting the Location of Mark Sensor
Model
CJV150/300
Issued
2014.09.15
Revised F/W ver. Remark
1.0
Rev.