© 2014 MIMAKI ENGINEERING CO.,LTD. 6.2.12 P.4
6.2.12 Changing Joint
1
2
3
4
5
6
7
8
Work procedures
Removing the joints:
1. Execute [#ADJUST] — [HEAD WASH / DISCHARGE] to dis-
charge the ink. (Refer to 4.2.8)
2. Remove the Cartridge rear cover.
3. Remove the Tube and Fiitings Assy.
4. Attach the Stopper (M700865) to the Joint (FittingΦ2:
M603013-07, accessory parts), and attach it to the 3-way fitting.
Be sure to wear protective glasses and working gloves during the operation.
Ink may get into your eyes depending on the working condition, or hand skin may get rough if you touch
the ink.
Make sure that O-ring (F seal rubber 300) is not
remaining in the joint screws.
Take care not to contaminate the surroundings with
ink.
Stopper
Use accessory joints
Do not install the ink tube in the wrong position.
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Ink-related Parts > Changing Joint
Model
CJV150/300
Issued
2014.09.15
Revised F/W ver
1.00
Remark
1.0
To Next Page
Loading...
