© 2014 MIMAKI ENGINEERING CO.,LTD. 6.3.4 P.2
6.3.4 Y Drive Belt
1
2
3
4
5
6
7
8
5. Slide out the connection point of the Y drive belt, and remove
either the left or right Belt presser (screw x1) from the belt
holder, and remove the Y drive belt.
6. Stick together the ends of the old belt and the new belt using
rubber tape or the like, and make one revolution of the belt.
7. Once the belt has made one revolution, remove the joining tape
and pass the belt through the rear side of the slider.
8. Align the Belt holder and the teeth on the left and right belt
ends, and attach the belt presser to the Belt holder while engag-
ing the teeth. Then tighten the screw.
9. Attach the belt holder and slider using a screw.
10. Tighten the screws on the Y-SP plate on the left side of the main
body, and increase the Y drive belt tension.
11. Reverse the disassembly procedure for the subsequent
reassemblies
Make one revolution
of the belt.
Tape
New belt
Engage the tooth of belt ends with
belt holder.
Belt Holder
■ Adjustment belt length:
1)Cut the belt that the gap in below figure becomes 3 - 5mm.
2)If you cut too much: Bump engagement with the belt holder can be
reduced by one bump.
1 bump short is OK
Belt holder
Driven pulley side
3-5mm
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Drive System > Y Drive Belt
Model
CJV150/300
Issued
2014.09.15
Revised F/W ver
1.00
Remark
1.0
To Next Page
Loading...
