Chapter 4 Maintenance
4-14
4
Clean the wiper and the bracket.
(1) Pull out the wiper by holding the protrusions at both the ends.
(2) Use a clean stick soaked in washing liquid.
• Wipe it off properly so that there is no residual washing liquid.
(3) Hold the wiper by the protrusions at both the ends and push it back to the original position.
5
Press the [ENTER] key.
CAP CLEANING
[ENT]
COMPLETED (NEXT)
• [COMPLETED (NEXT): ENT] is displayed on the screen until the cleaning of the cap is complete.
Press the [ENTER] key after Step 6 is complete.
If you press the [ENTER] key before the cleaning is complete, the machine moves to the next
washing step.
6
Clean the cap rubber and cap rubber cover.
• Wipe off any ink on the cap rubber and the cap rubber cover using a clean stick soaked in washing
liquid.
Wipe it off properly so that there is no residual washing liquid.
• At this time, the discharge passage is cleaned automatically.
Cap rubber
Cap rubber
cover
7
Press the [ENTER] key.
FILL THE LIQUID.
[ENT]
COMPLETED (NEXT)
• [COMPLETED (NEXT): ENT] is displayed on the screen until the washing liquid is filled. Press the
[ENTER] key after Step 8 is complete. If you press the [ENTER] key before the washing liquid is
filled, the carriage returns to its original position.
To Next Page
Loading...
