ii
Adjusting the Head Height ..............................................2-14
Setting the printing area ..................................................2-17
Setting leaf media ...........................................................2-18
Changing the printing origin ............................................2-19
Preparing for the Heaters ............................................... 2-20
Setting the heater ...........................................................2-20
Setting the adsorption fan ...............................................2-21
Setting the drying fan ......................................................2-22
If ruck is generated on the printing surface of the
media ..............................................................................2-22
Test Printing .................................................................... 2-23
Test Printing ....................................................................2-24
Head Cleaning ................................................................ 2-25
About head cleaning .......................................................2-25
Perform head cleaning depending on the test printing
result ...............................................................................2-25
Set the media feeding ..................................................... 2-26
Setting Feed Correction ..................................................2-26
Checking the media feeding amount deviation during
printing ............................................................................ 2-28
Setting Feed Check Pattern ............................................2-28
Aligning the Print Result Lengths .................................... 2-30
Setting Feed Check Pattern ............................................2-30
Correct the ink drop position for bidirectional printing ..... 2-32
Printing Data ................................................................... 2-34
Starting a Printing Operation ..........................................2-34
Stopping a printing operation halfway .............................2-35
Deleting Received Data (Data Clear) .............................2-35
Using method of weight for assistant roller ..................... 2-36
Chapter 3 Extended Functions
List of Functions ................................................................ 3-2
Setting Logical Seek ......................................................... 3-3
Setting Drying Time .......................................................... 3-4
Perform setting to reduce stripes between passes ........... 3-5
Setting Auto Cleaning ....................................................... 3-7
Setting nozzle face cleaning time ..................................... 3-8
Set the scanning speed and the feeding speed during
printing .............................................................................. 3-9
Other Settings ................................................................. 3-11
Machine Settings ............................................................ 3-12
Setting a AUTO Power-off ..............................................3-13
Setting the Display of Media Residual ............................3-14
Setting the Feed Compensation Mode ...........................3-16
Setting Time ....................................................................3-17
Setting Units ...................................................................3-18
Setting a KEY BUZZER ..................................................3-19
Setting a LANGUAGE .....................................................3-20
Initializing the Settings .................................................... 3-21
Confirming Machine Information ..................................... 3-22
To Next Page
Loading...
