MIMAKI UJV500-160 - Setting the Amount of Blank Space between Printed Lines

3-33
1
1
3
Convenient use
5
6
Machine Settings
Setting the amount of blank space between printed lines
Setting the amount of blank space between printed lines.
1
Press the key in LOCAL.
2
Press to select [MACHINE SETUP].
3
Press the key.
4
Press to select [SPACE BTWN PP.].
5
Press the key.
6
Press to set the amount of blank space.
• Set value : OFF / 10 to 500mm
7
Press the key.
8
Press the key several times to end the setting.
Back-feed operation is performed when printing ends if the amount of blank space is set in the
decreasing direction.
Be careful of the following in such cases.
• When printing multiple pages, the LED exposes the trailing edge of the previous data when printing of
the next pages starts, possibly causing the only the trailing edge to be over-cured.
• If media is set in the roll holder without using the feeding device on the back of the printer, the media
tension of the next printing will change due to back-feed, possibly causing the feed rate of the media
of only the leading edge of the printed image to change. In such cases, manually rewind the media.
• This function is disabled if back-feed after drying feed is set to OFF in the machine settings “DRYING
FEED”. ( P.3-32)
• If the printed data already has a blank space, using this function will result in “Blank space of the data
+ Amount of blank space set by using this function” being output as a blank space.
FUNCT I ON
SETUP <ENT>
FUNCT I ON
MACH I NE S E TUP [ ENT ]
MACH I NE S E TUP
AUTO Powe r - o f f [ ENT ]
MACH I NE S E TUP
SPACE BTWN PP . [ ENT ]
SPACE BTWN PP .
=OFF
SPACE BTWN PP .
=100mm
MACH I NE S E TUP
SPACE BTWN PP . [ ENT ]