2-10
Setting a Roll Media
Set a roll media to the feeding device on the back.
When setting a roll media, set “Setting the feeding and take up” of the machine setting to “ON”.
1
Set both of “FEED” and “ROLL” in “Setting the feeding and take up” of the machine
setting to “ON”.( P.3-24)
2
Remove the roll shaft on the feeding device at the back of this machine.
(1) Loosen the cover fixing screw attached to the cover of right/ left of media feeding device and
unlock the AMF lock by sliding it.
(2) Open the covers.
(3) Remove the roll shaft.
• To prevent dust, set paper core or media to the roll shaft on the table or sheet.
Dust on the paper core or the media may cause defective print.
• Take care not to drop the media on your foot when setting the media.
• Handle clamp levers carefully.
Do not push the lever up when tension-bar is lifted. Be sure to fix the tension-bar with the lock and
push up / down the lever.
When using the media take-up machine, be careful about the points below:
• Set the feeding side to match the print side.
• When the media is set on the narrow roll holder, remove the media. In addition, move the
narrow roll holder to the both edges of the machine. It may cause media feeding defect.
• When carrying the roll shaft, be sure to grip handles on the both ends. Gripping other
parts, your hand may get stuck in the printer.
To Next Page
Loading...
