2-14
11
Pass the media under the UV shielding cover and the post cure unit.
(1) Pass the media under the UV shielding cover.
(2) Open the post cure unit to the front and pass the media.
(3) Close the post cure unit.
12
Pull out the media.
• Holding both sides of the media, pull it out so that the media top edge comes below the floor by about
50cm.
• To set the media straight, pull out the media long.
13
Close the covers on the right and the left sides of the feeding device at the back of
this machine.
• After closing the cover, slide the AMF lock to the locking position and tighten the cover fixing screw.
• When you open/ close the post cure unit,
hold the handle at the front.
Check the position of the media edge surface and the feed roller.
• When you clamp the media edge surface
with the pinch roller and the feed roller, the
quality of transferring media may be
degraded. Before setting media, adjust the
position of the roll holder fixing the media.
To Next Page
Loading...
