MIMAKI UJV500-160 - Test Feeding

2-29
1
2
Basic Operations
4
5
6
Test Feeding
Perform this function before printing, and check whether the media can be fed normally.
1
Press the key in LOCAL three
times.
2
Press the key.
3
Press to select ON/OFF.
4
Press the key.
5
Press to select OFF.
6
Press the key.
7
Press the key.
• Start test feeding.
8
Press the key.
• The feeding operation is continued until you press the key.
• Feed it to some extent and check the feeding status, and then press the key to terminate.
• When setting "ON", rewind the roll media to
take up the slack before printing.
• When “Manual Drying Feed” is operated, select
“ON”. ( P.2-40)
• For “manual Drying Feed”, when you open the
shading cover while the post cure lights, the post
cure is turned off. However, the operation will
continue.
TEST FEED
[ENT]
BACKWARD FEED
:ON
BACKWARD FEED
:ON
POST CURE
:ON
POST CURE
:OFF
TEST FEED
START [ ENT ]
** TEST FEED **
PLEASE : WA I T