MIMAKI UJV500-160 - Setting Uv Mode

3-9
1
1
3
Convenient use
5
6
Setting UV mode
11
Press to set the irradiation pattern.
• Set values : Pattern A to F
• The following indicates the recommended printing mode for each
irradiation pattern.
12
Press the key.
13
Press to set the level for the intensity of
the LED UV device.
Set Value : 1 to 10 (Default=5)
• The intensity is at maximum with the setting value of 10.
• Decreasing the level reduces the intensity.
14
Press the key.
15
Press the key several times to end the setting.
Ink set 4-colors 4-colors + white/ 6-colors + white
Pattern A
300x450HQ Not normally used
Pattern B
600x600, 600x900 300x450HQ single-layer, 600x600 single-layer
Pattern C
1200x1200
600x900 single-layer; 1200x1200 single-layer
300x450HQ two-layers, 600x600 two-layers
600x900 two-layers
Pattern D
Not normally used For Three-layers printing
Pattern E
If adhesion is poor with patterns A to D:
If adhesion is poor with patterns A to D:
(Color-only printing; Color  White printing)
Pattern F
If adhesion is poor with patterns A to D:
If adhesion is poor with patterns A to D:
(White-only printing; White  Color printing)
• Depending on the level setting, a UV-related error, such as overheating, may occur. If an error occurs,
set the intensity to a lower level.
UV MODE
:PATTERN D
UV MODE
LEVEL : 10
UV MODE
LEVEL : 5
SETUP
UV MODE [ ENT ]