MIMAKI UJV500-160 - Printing Data; Starting a Printing Operation

2-38
Printing Data
Starting a Printing Operation
1
Setting a Media ( P.2-5)
2
Checking the Heater Temperature
• Check the CONSTANT lamp lights in [PRE], [PRINT], and
[POST] below the display.
3
Press the key in LOCAL.
• If the heater temperature has not reached the setting value, the
right screen is displayed.
Even if it has not reached, you can move to REMOTE when
pressing the key.
• The screen changes to REMOTE, and data can be received from
the PC.
4
Transmit data to be printed from the PC.
• The printing conditions are displayed.
• For the method of data transmission, see the instruction
manual for the output software.
5
Start printing.
• When using a roll media, rewind the media by hand before printing so that it is not loose.When the roll
media has not been rewound tightly, it may cause the image quality to deteriorate.
TEMPERATURE CONTROL !
PLEASE WA I T
600x900 R/MP2/ALL
6.Bd.Nd.x2 xx.xxm
Resolution : 600 /900 DPI
Number of passes
The length of media
drawn
Scan direction
Ud : Unidirectional
Bd : Bidirectional
Data type
VD : Variable data
ND : Normal data
Scanning speed
x1 : Standard speed
x2 : Double speed
With/ without nozzle recovery setting
(Operates with nozzle recovery enabled
when “R” is displayed)
With/ without MAPS setting
MP1 : MAPS1
MP2 : MAPS2
Heads used for
printing