1-14
4
Take out the 1 liter ink bottle, and slowly shake it twenty times and more.
• To prevent ink from leaking when you shake it, wear gloves and cover the ink bottle cap with a paper
towel etc. Being in that status, slowly shake it twenty times and more by flowing ink.
5
Remove the cap of the ink bottle set in the external
ink supply unit.
• First, cover the cap with a waste cloth etc. to prevent your
hands from getting dirty and then remove it.
6
While checking the ink remaining amount
indicator, add ink.
• Depending on the ink type, aluminum sheet adheres to the
bottle top surface. In such a case, remove it with a cutter.
• While checking the ink remaining amount indicator above
the ink bottle, add ink. For details, refer to P.1-25 “Rough
standard for adding ink”.
• Before shaking it, check that the cap is firmly closed.
• If you shake it too strong, it may cause ink leakage. Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the bottle cannot be beaten enough. Tilt the
ink bottle until it becomes vertical.
To Next Page
Loading...
