Maintaining the Capping Station
4-7
1
1
1
4
Routine Maintenance
10
Clean the wiper blade.
• Soak the clean stick in the maintenance cleaning liquid, and
then remove the ink that has adhered to the wiper blade.
11
Clean the cap rubber and cap rubber cover.
• Wipe off the ink sticking to the cap rubber and cap rubber
cover with a clean stick dipped in cleaning solution for
maintenance.
Wipe off so that cleaning solution for maintenance will not
remain.
• Make sure to be careful with the edge of the
wiper blade, and thoroughly clean the side
(back side) where the wiper touches.
• Clean the wiper blade until it looks as shown
in the photo below.
• Clean the wiper until it
looks as shown in the
photo on the right.
• Make sure that the cap
rubber and mesh inside
the cap have not come
off after cleaning.
To Next Page
Loading...
