Maintenance
4-4
Cleaning the Media Sensor
The media sensors are located on the platen in the backside and the bottom surface of the head. When the
sensor is covered with dust, etc., it may cause false detection of media.
Using a cotton swab, remove the dust, etc. accumulated on the surface of the sensor.
When cleaning the sensor on the lower surface of the head is cleaned, move the carriage to the left end by the
operations of step 1 of P.4-13 “Cleaning the Head and the Area around It”, and then clean it.
Cleaning the Media Press
When the media press is covered with lint, dust, etc., a media cannot be fed normally during printing or dust
sticks to the nozzles, which may result in abnormal printing.
Clean the media press regularly with a dry cloth or paper towel.
If there is ink on the media press, wipe it away with a clean stick dipped in washing liquid for maintenance.
• When using washing liquid for maintenance, be sure to wipe it away completely so that none remains
on the media press.
To Next Page
Loading...
