MIMAKI UJV500-160 - Setting MAPS1 Function

3-14
Setting MAPS1 Function
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [MAPS].
4
Press the key.
5
Press to select MAPS1.
•Set Value：MAPS1, MAPS2, OFF
6
Press the key.
• If you selected MAPS2 or OFF in step 5, proceed to step 8.
7
Press to change print speed.
• Set Value:-50 to +50%
8
Press the key.
9
Press the key several times to end the setting.
• When you change the speed, nozzle recovery effect cannot work in some cases. Use it
after checking.
FUNCT I ON
SETUP [ ENT ]
SETUP
FEED COMP . [ ENT ]
SETUP
MAP S [ EN T ]
MAP S
:OFF
MAP S
:MAPS 1
PR I NT SPEED ADJUST
=0%
PR I NT SPEED ADJUST
=10%
SETUP
MAP S [ EN T ]