MIMAKI UJV500-160 - Chapter 2 Basic Operations

This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow .......................................................2-2
Turning the Power ON/OFF ..........................2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-4
Setting a Media .............................................2-5
Setting the Head Gap .................................. 2-5
Note for media setting ................................. 2-6
Setting a roll media ..................................... 2-7
Setting leaf media ..................................... 2-25
Changing the printing origin ...................... 2-27
Preparing for the Heaters ............................2-28
Changing the Temperature Settings for the
Heaters ...................................................... 2-28
Checking the Heater Temperature ............ 2-28
Test Feeding ...............................................2-29
Test Printing ................................................2-30
Test Printing .............................................. 2-31
Head Cleaning ............................................2-32
About head cleaning ..................................2-32
Perform head cleaning depending on the
test printing result ......................................2-32
Set the media feeding .................................2-34
Setting Feed Correction .............................2-34
Correct the ink drop position for
bidirectional printing ....................................2-36
Printing Data ...............................................2-38
Starting a Printing Operation .....................2-38
Stopping a printing operation halfway ........2-39
Deleting Received Data (Data Clear) ........2-39
Behavior after printing
has been completed ..................................2-39
Cutting a media ..........................................2-41
Chapter 2
Basic Operations