Front cover
Open the cover in setting of medias, taking of measures
against jamming of medias or in maintenance inside the
station.
Even when the power button is off, keep this cover and the
other covers closed.
Operation panel
This panel has the operation keys
required for operating the machine and
the LCDs for displaying setting items,
etc.
Clamp lever (front)
Moves the pinch rollers up and down to hold
or release the media.
Waste ink tank
Waste ink gathers in this tank.
Stand
Supports the main body of the machine.
Left maintenance cover
Open the cover in maintenance.
Even when the power button is off,
keep all covers closed.
Ink bottle
Each bottle
contains an ink of
a particular color.
Narrow Take-up device
Take up the output drawn with a roll
medium automatically.
Lower right maintenance cover
Open the cover in maintenance.
External ink supply unit
Set the ink bottle.
Platen
The printed media is sent out, sliding on the platen. Three
heaters are installed inside the platen.
Print heater/ Pre-heater/ Post-heater
Fixes and dries the ink on the currently produced print.
(Located inside the platen)
Upper right maintenance cover
Open the cover in maintenance.
Post cure unit
The lamp unit to cure printed ink
Take-up VTTS
Take up the output drawn with a
roll medium automatically.
To Next Page
Loading...
