MIMAKI UJV500-160 - Changing the Printing Origin

2-27
1
2
Basic Operations
4
5
6
Setting a Media
Changing the printing origin
The position of the printing origin can be changed.
1
In Local, Press .
• It enters into the origin setting mode.
2
Press to set the origin to a desired position.
• Select the carriage and media, moving the point with
.
• When you press the key here, you can perform
media cutting.
3
After determining the origin, press the key.
• The printing origin is changed.
Typical setting position of printing origin
The printing origin in the depth direction (X') is positioned
at about 75 mm rearward from the slot for cutting on the
platen. The printing origin in the scanning direction (Y') is
positioned at 15 mm from the right end of the media. The
value in the scanning direction (Y') can be changed using
[MARGIN] in FUNCTION mode.
( P.3-2) This can be changed by using the Jog key.
OR I G I N SE TUP
0.0 ----
OR I G I N SE TUP
0.0 0.0
Origin
(Length)
Origin
(Width)
OR I G I N SE TUP
** ORIGIN **
slot for cutting
approx. 75 mm
(X’)
25 mm
(Y’)