MIMAKI UJV500-160 - Page 60

2-26
4
Hold the media with the media press gently.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
• When using a thick media, remove the media press from
the media before printing.
5
Push down the clamp lever.
• Set the media straight.
6
Close the front cover.
7
Press the key.
8
Press the key to select "LEAF" .
9
The media detection is started.
(1) The media width is detected.
(2) It returns to the LOCAL when the detection is completed.
• If the media gets to the right or the left too much,
the next warning is displayed to inform you of it
after media detection. By referring to the media
setting position nameplate attached with the main
body, reset the media.
Media press
ERROR 516
MED I A SE T POS I T I ON R
ERROR 516
MED I A SE T POS I T I ON L
MED I A SE L ECT
ROL L < > L EAF
** MEDIA DETECT **