MIMAKI UJV500-160 - Setting Margins

3-6
Setting Margins
Set a non-printing area along the right and left edges of the media.
The offset value against the standard margin 15mm is set hereupon.
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [MARGIN].
4
Press the key.
5
Press to set the left margins.
• This was set to “HOST” (RIP software side setting has priority)
before shipping. Change this when you want to set the left margin
of media to the setting value of this machine.
Set Value : HOST or -10 to 85mm (in 1mm increment)
6
Press the key.
7
Press to set the right margins.
• This was set to “HOST” (RIP software side setting has priority)
before shipping. Change this when you want to set the right
margin of media to the setting value of this machine.
Set Value : HOST or -10 to 85mm (in 1mm increment)
8
Press the key.
9
Press the key several times to end the setting.
• When you give priority to the setting at the RIP software side, make the setting value “Host”.
• You cannot specify the margins at the attached RIP software (RasterLink). When you use the
RasterLink, if you set this machine to “Host”, printing will be performed in “Margins for right and left off
set value= 0 mm” status.
• Pay attention to that printing may start on the media press if a right and left margin is set to 5 mm or
less when the media press is used in printing.
FUNCT I ON
SETUP [ ENT ]
SETUP
FEED COMP . [ ENT ]
SETUP
MARG I N [ ENT ]
LEFT
=0mm
LEFT
=HOST
RIGHT
=0mm
RIGHT
=HOST
SETUP
MARG I N [ ENT ]