5-10
Warning / Error Messages
If some trouble occurs, the buzzer sounds and the display shows a corresponding error message.
Take an appropriate remedy for the displayed error.
Warning messages
Errors when performing operations
Message displayed in LOCAL
Message Cause Solution
The front cover or the maintenance
cover is opened.
• Check the front cover and maintenance
covers.
• If the same error message appears again
even after closing all the covers, contact
your local distributor to call for service.
The media has not been detected. • Perform media detection.
The motor is OFF after the cover was
opened etc.
• Close the front cover and maintenance
covers (right and left).
An ink error occurred.
• Check the ink bottle for the supply path
corresponding to the indicated color.
Data was received. • Perform data clear. ( P.2-39)
Message Cause Solution
Ink errors (unusable ink) occur in multi-
ple ink bottles.
Ink supply (print, cleaning, etc.) cannot
be performed.
• Press the key to check the ink
bottle generating the warning.
Replace them with usable ink bottles.
The waste ink tank is full.
• Check the waste ink tank.
The waste ink tank is nearly full.
The waste ink tank is not set. • Set the waste ink tank.
Time to replace the wiper in the capping
station with a new one has come.
(The wiping count has reached the
specified value.)
• Press the key and replace the
wiper with a new one. ( P.4-31)
The media is not set.
The sensor has been broken.
• Set the media. ( P.2-7) If the same
error message appears again, contact
your local distributor to call for service.
The data has been received.
• Press the key to perform print-
ing. Or, perform data clear.
To Next Page
Loading...
