MIMAKI UJV500-160 - Setting MAPS2 Function (4 Color)

3-15
1
1
3
Convenient use
5
6
Perform setting to reduce stripes between passes
Setting MAPS2 Function (4 color)
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [MAPS].
4
Press the key.
5
Press to select MAPS2.
•Set Value：MAPS1, MAPS2, OFF
6
Press the key.
• If you selected OFF in step 5, proceed to step 12.
7
Press to select “AUTO” or “MANUAL”.
• AUTO : Set the print pattern and smoothing level to the
recommended value automatically depending on
printing mode.
• MANUAL : You can adjust the set value.
8
Press the key.
• When selecting the “AUTO” in the Step 7, proceed to the step 12.
• When selecting the “MANUAL” in the Step 7, proceed to the step 9.
9
Press to select pattern to print.
• Set value：Pattern1 to Pattern 5
10
Press the key.
• If feeding stripes and color change is not improved by “AUTO” setting, please adjust the
print pattern and smoothing level by “MANUAL” setting.
• MAPS2 effect differs depending on image to be printed. Change the printing pattern and
use it after checking effect in advance.
FUNCT I ON
SETUP [ ENT ]
SETUP
FEED COMP . [ ENT ]
SETUP
MAP S [ EN T ]
MAP S
:OFF
MAP S
:MAPS 2
MAP S 2
:AUTO
MAP S 2
:AUTO
MAP S 2
PATTERN : 1
MAP S 2
PATTERN : 2
MAP S 2
SMOOTH I NG LV . : AUTO