MIMAKI UJV500-160 - Cutting a Media

2-41
1
2
Basic Operations
4
5
6
Printing Data
Cutting a media
When you cut the media after printing of roll media has been completed, cut it with the key on the operation
panel.
1
Press the key twice.
2
Press the key.
3
Press to specify the cutting position.
4
Press the key.
• The media is cut.
• When the cutting has been completed, the current mode returns to LOCAL.
• When a media is cut, be careful that the printed side does not touch the floor or the printed side of
other already cut media.
• When using the take-up device, take up a cut medium using the switch of the take-up device.
• During the origin setting with the jog keys, you can also perform media cutting by pressing the
key. ( P.2-27)
MED I A CUT
[ENT]
MED I A CUT
CUT POS I T I ON [  ]
CUT POS I T I ON
0.0 ----
** CUTTING **
PLEASE WA I T