MIMAKI UJV500-160 - Page 74

2-40
Manual Drying Feed
When the operation is cancelled before prints are fed under UV lamps, such prints need to be dried/cured by
manual feeding.
1
Press the key in LOCAL three
times.
2
Press the key.
3
Press to select ON/OFF.
4
Press the key.
5
Press to select ON.
6
Press the key.
7
Press the key.
• After the heater and the UV lamp are ready, start test feeding.
8
Press the key.
• Continue feeding until the media on the platen surface passes through the post cure unit.
• To stop feeding, press the key.
• When setting "ON", rewind the roll media to take
up the slack before printing.
TEST FEED
[ENT]
BACKWARD FEED
:ON
BACKWARD FEED
:ON
POST CURE
:OFF
POST CURE
:ON
TEST FEED
START [ ENT ]
** TEST FEED **
PLEASE : WA I T